Plasma/Laser/Torch Cutting Tables

1. Plasma Smoke Collection System

Airex DCCH 30 with cyclone prefilter collecting plasma smoke from a 15’ X 30’ cutting table burning up to 4” stainless steel. This system is equipped with a HEPA final filter in order to meet the new OSHA limits.

2. Dust Collector for Plasma Smoke

Farr Model GS - 24 (Gold Series) Dust Collector collecting plasma cutting smoke from a Messer 6 ft X 10 ft. Cutting Table.

3. Plasma Cutting Table

Messer 6 ft. X 10 ft. Cutting Table using a Farr Model GS - 24 (Gold Series) Dust Collector to collect plasma cutting smoke.

4. Collection for Powder Torch #1

A 6400CFM Airex Model DCCH – 40 Dust Collector with an Airex (Pre-Filtering) Cyclone collecting smoke and dust from a powder torch process that is cutting stainless steel up to 12 inches thick.

5. Collection for Powder Torch #2

An inside view of the ductwork that is connected to the powder torch process.

6. Collection for Powder Torch #3

A close-up of the powder torch process in operation while dust and smoke are being extracted.

7. Collector for Plasma Cutting

Clean Air America Model DFC – 18 Dust Collector collecting smoke and dust from a 5ft x 10 ft Cybermation Model 700A - Plasma Cutting Table.

8. Collector for Laser Cutting

Clean Air America Model DFC – 18 Dust Collector collecting smoke and dust from a Mazak Laser Cutting Machine.

9. Steel Cutting Dust Collection #1

Cutting large steel parts with burning bars.

10. Steel Cutting Dust Collection #2

Airex DCCH 112 collecting heavy steel cutting smoke.

11. Heavy Plasma Smoke Collection #1

Airex DCCH-20 20 HP cartridge dust collector with Automatic Hi-Temperature shut-off and factory installed fire suppression system. It is collecting heavy plasma cutting smoke from a 5' wide x 10' long plasma cutting table.

12. Heavy Plasma Smoke Collection #2

Plate-Pro plasma table cutting 3/8" carbon steel.

13. Collection System With Moving Hood #1

Two Airex Model DCCH 20 Dust Collectors with spark traps and HEPA after filters, used for the collection of smoke from plasma cutting tables.

14. Collection System With Moving Hood #2

A canopy hood with side curtains is mounted on the plasma table gantry to collect the cutting smoke and follows the torch up and down the table.

15. Collection System With Moving Hood #3

Each canopy hood is attached to a Zipper duct to allow the hood to move up and down the length of the plasma table.

16. Portable Plasma/Welding Booth

Portable cutting booth with built in dust/smoke collection system, to be used with Air Arc Gouging or plasma cutting and welding. This unit can be moved with the overhead crane or large fork lift.